Forged engine build – build up

As I mentioned, I decided to re-use the existing block and keep the ‘new’ one on the shelf as a spare. The bores were just in such good condition… still!

OLYMPUS DIGITAL CAMERA

I borrowed a honing tool which looks more like a bunch of grapes:

OLYMPUS DIGITAL CAMERA

Honing tool

After a few passes up and down using a cordless drill the bores were nicely honed.

OLYMPUS DIGITAL CAMERA

Bores honed

Next was to assemble the pistons. The first job was to attach the pistons to the rods. The pistons came with the pins and clips required, so it was just a case of plenty of lube and plenty of patience! Just the one clip got pinged across the garage and amazingly was found again.

Then it was time for the piston rings. Oil scrapers first with a spacer in the middle. These go at the bottom of the piston.

Then it was the compression rings. These have a certain way up but it wasn’t difficult to work out.

With all the pistons and rods fully assembled, the block was rebuilt!

OLYMPUS DIGITAL CAMERA

That would be the oil and flash that makes it look like the bores are shiny – they really weren’t!

It was then time to say goodbye to the lovely shiny new bits and fit the new headgasket and head.

I decided to remove the adjustable cam pulleys as being forced induction I wouldn’t need to play with them. I refitted the standard ones and timed the engine up.

OLYMPUS DIGITAL CAMERA

And back on with the covers:

OLYMPUS DIGITAL CAMERA

Probably should have cleaned them up a bit better really. Never mind.

 

Advertisements
This entry was posted in Performance upgrades. Bookmark the permalink.

2 Responses to Forged engine build – build up

  1. Lewis Biggs says:

    I do believe your cambelt is rather loose in that last picture, was this something you picked up on or did you find out the hard way?

    • Dom says:

      Not the hard way, fortunately! If I remember rightly it was when I was taking off the crank locking tool and realised I hadn’t tightened the tensioner and rotated the crank.

      I’d had to look at this photo many times before – I was trying to work out why I had a cold start issue and thought the timing may have been out. It was the only photo I had and wasn’t good enough so I had to remove the covers again in situ to check. Doubly annoying – it was fine!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s